HOW
TO APPLY HOUSE OF KOLOR FLAKES
CHOSEN COLOUR F20
RED FLAKE OVER BC25 BLACK BASECOAT
LARGE SIZE
CAR
Stage 1
Prior to sanding please degrease with KC10 Wax and Grease
remover. If you are applying direct to any Bare Metal, Fibreglass
or Polyester. Mix KP2CFAQ Kwikure Epoxy Primer Part A 1:1
with KP2CFBQ Kwikure Epoxy Primer Part B. Apply 1: 3 coats
to all above areas for adhesion. Sand down when dry with 180
grit Disc and then finish with 240 grit Disc.
Stage 2
KS11 Ko-Seal Black Metallic Primer Sealer. Mix 4-1-1 with
KU100 catalyst and RU311 medium reducer. Apply 1-2 single
coats to all areas. Leave to dry for 2-3 hours. If left any
longer dry nib with 800 dry disc or abralon pad.
Stage 3
BC25 Black Basecoat mix 2-1 with RU311 Reducer. Apply 3-4
single coats over all Ko-sealed areas. You can wet nib between
coats 2 and 3 if required. Leave to stand for 30-40 minutes
after last coat.
Stage 4
Mix SG150 Intercoat Pearl & Flake Karrier 1:1 with RU311
medium reducer. Then please add 1-2 level teaspoon full to
every ½ mixed pearl and reducer. Then apply 1-2 coats
over the BC25 Black Basecoat depending on your desired effect.
After application apply 1-2 coats of SG100 Intercoat Klear
Mix 2:1 with RU311 medium reducer Then please leave to dry
for 1-2 hours.
Stage 5
UC35 Kosmic Polyurethane Klear. Mix 2-1-1 with KU100 and RU311
reducer. Apply 3 single coats and leave to dry for 4 days
or low bake for 1 hour at 600 C. De nip with 800 grit wet/dry
and polish with Meguiars solo one liquid system.
MATERIALS
1 X GAL KC10 WAX &
GREASE REMOVER
1 X QT KC20 POST SANDING CLEANER
3 X QT KP2CFAQ KWIKURE EPOXY PRIMER PART (A)
3 X QT KP2CFBQ KWIKURE EPOXY PRIMER PART (B)
2 X QT KS11 BLACK METALLIC PRIMER SEALER
5 X QT BC25 BLACK BASECOAT
3 X QT SG150 INTERCOAT PEARL & FLAKE KARRIER
3 X QT SG100Q INTERCOAT
1 X 6oz F20 RED FLAKE
1 X GAL UC35 KOSMIC KLEAR
3 X QT KU100 CATALYST
2 X GAL RU311 MEDIUM REDUCER
2 X QT RU311 MEDIUM REDUCER
For Techical support please contact Peter Moore
on 07715176989
|
[
